Show simple item record

dc.contributor.authorR. Parker Eason
dc.contributor.authorAndrew J. Dick
dc.date.accessioned2017-05-09T00:49:18Z
dc.date.available2017-05-09T00:49:18Z
dc.date.copyrightJanuary, 2012
dc.date.issued2012
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-25516#011010_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148539
dc.description.abstractDisplacement measurement in atomic force microscopy (AFM) is most commonly obtained indirectly by measuring the slope of the AFM probe and applying a calibration factor. Static calibration techniques operate on the assumption that the probe response approximates single mode behavior. For off-resonance excitation or different operating conditions the contribution of higher modes may become significant. In this paper, changes to the calibrated slope-displacement relationship and the corresponding implications on measurement accuracy are investigated. A model is developed and numerical simulations are performed to examine the effect of laser spot position, tip mass, quality factor and excitation frequency on measurement accuracy. Free response conditions and operation under nonlinear tip-sample forces are considered. Results are verified experimentally using a representative macroscale system. A laser spot positioned at a nominal position between x = 0.5 and 0.6 is determined to minimize optical lever measurement error under conditions where the response is dominated by contributions from the first two modes, due to excitation as well as other factors.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResponse Measurement Accuracy for Off-Resonance Excitation in Atomic Force Microscopy
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4005361
dc.journal.fristpage11010
dc.identifier.eissn1528-9028
dc.keywordsResonance
dc.keywordsForce
dc.keywordsLasers
dc.keywordsAtomic force microscopy
dc.keywordsDisplacement
dc.keywordsErrors
dc.keywordsProbes
dc.keywordsAccuracy and precision
dc.keywordsCalibration
dc.keywordsComputer simulation
dc.keywordsShapes AND Q-factor
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2012:;volume( 134 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record