Show simple item record

dc.contributor.authorRamamurthy V. Dwivedula
dc.contributor.authorPrabhakar R. Pagilla
dc.date.accessioned2017-05-09T00:49:11Z
dc.date.available2017-05-09T00:49:11Z
dc.date.copyrightMay, 2012
dc.date.issued2012
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26586#031010_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148492
dc.description.abstractA dynamic model to describe the effect of compliance in a transmission system is presented. Analysis of this model shows that it is desirable to use feedback from driver-side of the transmission system. This model is extended to include the effects of both compliance and backlash in a mechanical transmission system. The proposed model considers compliance (which may be either due to the elasticity of the shafts or belt in a belt-pulley transmission system) and backlash appearing in series in a drive system. In contrast to the classical backlash model which considers both input and output to the backlash as displacements, the proposed model considers (torque) force as input to the backlash and (angular velocity) velocity of the driven member as the output of the backlash. Thus, the proposed model does not assume that the load is stationary when contact is lost due to backlash width, i.e., momentum of the load is taken into account. Using the proposed model, a bound on the speed error due to the presence of backlash is derived. Experiments were conducted on a rectilinear mass-spring system platform, which has a provision to change the backlash width by a known value. Experiments were conducted with different backlash widths and a velocity error bound was computed. The error bound obtained from the experimental results agrees with the theoretically computed bound.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Compliance and Backlash on the Output Speed of a Mechanical Transmission System
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4005493
dc.journal.fristpage31010
dc.identifier.eissn1528-9028
dc.keywordsForce
dc.keywordsMechanical drives
dc.keywordsStress
dc.keywordsGears
dc.keywordsErrors
dc.keywordsBelts
dc.keywordsSprings
dc.keywordsFeedback
dc.keywordsEngines
dc.keywordsPulleys AND Torque
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2012:;volume( 134 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record