Show simple item record

dc.contributor.authorGerry Slagis
dc.date.accessioned2017-05-09T00:46:40Z
dc.date.available2017-05-09T00:46:40Z
dc.date.copyrightApril, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28543#021102_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147485
dc.description.abstractPiping thermal expansion stress limits for ASME Section III Class 2 and 3 piping are directly based on the original thermal expansion rules for B31.1 piping published in 1955. Temperature limits for B31 piping are much higher than for Class 2/3 nuclear piping. The fundamental concern in 1955 for piping design was to prevent cyclic creep strains, and the thermal expansion rules were based on a strain range criterion. Fatigue was also a concern, and a stress-range reduction factor for cyclic conditions was incorporated into the strain-based rule. The history and development of the B31.1 thermal expansion rules are summarized. After review of the technical basis, it becomes evident that the nuclear Class 2/3 rules can be simplified and improved by changing to an explicit fatigue-based rule rather than the strain-based rule of B31.1. Recommended Section III code revisions are provided with discussion of related technical issues.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRecommended Revisions to Nuclear Piping Thermal Expansion Stress Limits
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4002256
dc.journal.fristpage21102
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsThermal stresses
dc.keywordsPipes
dc.keywordsThermal expansion
dc.keywordsFatigue
dc.keywordsTemperature AND Cycles
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record