Show simple item record

dc.contributor.authorHany F. Abdalla
dc.contributor.authorMohammad M. Megahed
dc.contributor.authorMaher Y. A. Younan
dc.date.accessioned2017-05-09T00:46:38Z
dc.date.available2017-05-09T00:46:38Z
dc.date.copyrightJune, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28546#031207_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147468
dc.description.abstractA simplified technique for determining the shakedown limit load for a long radius 90 deg pipe bend was previously developed (, , 2006, “Determination of Shakedown Limit Load for a 90 Degree Pipe Bend Using a Simplified Technique,” ASME J. Pressure Vessel Technol., 128, pp. 618–624; , , 2007, “Shakedown Limits of a 90-Degree Pipe Bend Using Small and Large Displacement Formulations,” ASME J. Pressure Vessel Technol., 129, pp. 287–295). The simplified technique utilizes the finite element (FE) method and employs the small displacement formulation to determine the shakedown limit load (moment) without performing lengthy time consuming full cyclic loading finite element simulations or utilizing conventional iterative elastic techniques. The shakedown limit load is determined through the calculation of residual stresses developed within the pipe bend structure. In the current paper, a parametric study is conducted through applying the simplified technique on three scheduled pipe bends, namely, nominal pipe size (NPS) 10 in. Sch. 20, NPS 10 in. Sch. 40 STD, and NPS 10 in. Sch. 80. Two material models are assigned, namely, an elastic perfectly plastic (EPP) material and an idealized elastic-linear strain hardening material obeying Ziegler’s linear kinematic hardening (KH) rule. This type of material model is termed in the current study as the KH-material. The pipe bends are subjected to a spectrum of steady internal pressure magnitudes and cyclic bending moments. The cyclic bending includes three different loading patterns, namely, in-plane closing, in-plane opening, and out-of-plane bending moment loadings of the pipe bends. The shakedown limit moments outputted by the simplified technique are used to generate shakedown diagrams of the scheduled pipe bends for the spectrum of steady internal pressure magnitudes. A comparison between the generated shakedown diagrams for the pipe bends employing the EPP- and the KH-materials is presented. Relatively higher shakedown limit moments were recorded for the pipe bends employing the KH-material at the medium to high internal pressure magnitudes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleShakedown Limit Loads for 90 Degree Scheduled Pipe Bends Subjected to Steady Internal Pressure and Cyclic Bending Moments
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4002055
dc.journal.fristpage31207
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress AND Pipe bends
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record