Show simple item record

dc.contributor.authorYinsheng Li
dc.contributor.authorKunio Hasegawa
dc.contributor.authorAkira Shibuya
dc.contributor.authorNathaniel G. Cofie
dc.date.accessioned2017-05-09T00:46:36Z
dc.date.available2017-05-09T00:46:36Z
dc.date.copyrightAugust, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28548#041207_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147449
dc.description.abstractWhen a flaw is detected in a stainless steel piping system, an evaluation has to be performed to determine its suitability for continued operation. The failure bending moment of the flawed pipe can be predicted by limit load criterion in accordance with Appendix E-8 in the JSME S NA-1-2008 and/or Appendix C in the ASME Code Section XI. However, in these current codes, the limit load criterion is only calculated for the case of pipes containing a single flaw with constant depth, although the actual flaw depth is variable along the circumferential direction. Particularly, geometrical shapes of stress corrosion cracks are generally complex. The objective of this paper is to propose a method by formula for predicting the load-carrying capacity of pipes containing a circumferential surface flaw with any arbitrary shape. The failure bending moment is obtained by dividing the surface flaw into several subflaw segments. Using this method, good agreement is observed between the numerical solution and the reported experimental results. Several numerical examples are also presented to show the validity of the proposed methodology. Finally, it is demonstrated that three subflaw segments are sufficient to determine the collapse bending moment of a semi-elliptical surface flaw using the proposed methodology.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFailure Bending Moment for Pipes With an Arbitrary-Shaped Circumferential Flaw
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4002927
dc.journal.fristpage41207
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsPipes
dc.keywordsCollapse
dc.keywordsFailure
dc.keywordsShapes
dc.keywordsASME Standards AND Stainless steel
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record