Show simple item record

dc.contributor.authorMikel Abasolo
dc.contributor.authorJosu Aguirrebeitia
dc.contributor.authorRafael Avilés
dc.contributor.authorIgor Fernández de Bustos
dc.date.accessioned2017-05-09T00:46:36Z
dc.date.available2017-05-09T00:46:36Z
dc.date.copyrightAugust, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28548#041202_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147443
dc.description.abstractThis paper presents a metamodel that enables estimation of the elastic interaction that occurs in the bolted joints of a wind generator tower during the tightening sequence. In this kind of joint, there is a gap between the contact surfaces of the flanges. The metamodel is composed of four parameters, which are enough to simulate the response of the flange under the tightening loads of the bolts. Even though the behavior of the joint is nonlinear because of the gap, the parameters are obtained from two simple linear elastic analyses of a finite element (FE) model of the flange. The corresponding loss of load in the bolts has been estimated for various sequences with minimum computational cost. Thus, there is no need for costly experimental measurements or nonlinear FE simulations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Tetraparametric Metamodel for the Analysis and Design of Bolting Sequences for Wind Generator Flanges
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4002541
dc.journal.fristpage41202
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFlanges
dc.keywordsGenerators AND Wind
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record