Show simple item record

dc.contributor.authorKhosrow Behseta
dc.contributor.authorDonald Mackenzie
dc.contributor.authorRobert Hamilton
dc.date.accessioned2017-05-09T00:46:36Z
dc.date.available2017-05-09T00:46:36Z
dc.date.copyrightAugust, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28548#041201_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147442
dc.description.abstractAn investigation of the cyclic elastic-plastic response of an Olefin plant heat exchanger subject to cyclic thermal and pressure loading is presented. Design by analysis procedures for assessment of shakedown and ratcheting are considered, based on elastic and inelastic analysis methods. The heat exchanger tube sheet thickness is nonstandard as it is considerably less than that required by conventional design by formula rules. Ratcheting assessment performed using elastic stress analysis and stress linearization indicates that shakedown occurs under the specified loading when the nonlinear component of the through thickness stress is categorized as peak stress. In practice, the presence of the peak stress will cause local reverse plasticity or plastic shakedown in the component. In nonlinear analysis with an elastic–perfectly plastic material model the vessel exhibits incremental plastic strain accumulation for 10 full load cycles, with no indication that the configuration will adapt to steady state elastic or plastic action, i.e., elastic shakedown or plastic shakedown. However, the strain increments are small and would not lead to the development of a global plastic collapse or gross plastic deformation during the specified life of the vessel. Cyclic analysis based on a strain hardening material model indicates that the vessel will adapt to plastic shakedown after 6 load cycles. This indicates that the stress categorization and linearization assumptions made in the elastic analysis are valid for this configuration.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRatcheting Assessment of a Fixed Tube Sheet Heat Exchanger Subject to In Phase Pressure and Temperature Cycles
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4003623
dc.journal.fristpage41201
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsTemperature
dc.keywordsStress
dc.keywordsDesign
dc.keywordsHeat exchangers
dc.keywordsCycles
dc.keywordsThickness
dc.keywordsVessels
dc.keywordsSteady state
dc.keywordsDeformation
dc.keywordsWork hardening
dc.keywordsElastic analysis
dc.keywordsStress analysis (Engineering) AND Industrial plants
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record