Show simple item record

dc.contributor.authorB. H. Wu
dc.contributor.authorZ. L. Wang
dc.contributor.authorG. E. O. Widera
dc.contributor.authorZ. F. Sang
dc.date.accessioned2017-05-09T00:46:34Z
dc.date.available2017-05-09T00:46:34Z
dc.date.copyrightOctober, 2011
dc.date.issued2011
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28550#051205_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/147424
dc.description.abstractThe objective of this study is to investigate the strength behavior and plastic limit pressure of hot-tapped pipelines under an internal pressure load. Two full scale test models were fabricated for the experiment. A three-dimensional nonlinear finite element analysis was also carried out. The plastic limit pressure was determined approximately by use of the twice the elastic-slope criterion. The results indicate that plastic limit pressures obtained by experiment and finite element analysis are in good agreement. On the basis of the above results, a parametric analysis of the plastic limit pressure was carried out and resulted in the development of formulas useful for the design of hot-tapped pipelines.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStrength Behavior of Hot-Tapped Pipeline Under Internal Pressure Load
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue5
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4003460
dc.journal.fristpage51205
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress
dc.keywordsPipelines
dc.keywordsPipes
dc.keywordsBifurcation AND Finite element analysis
dc.treeJournal of Pressure Vessel Technology:;2011:;volume( 133 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record