• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Heat Transfer to Flat Strips Immersed in a Fluidized Bed

    Thumbnail
    View/Open
    JHTRAO-27917#071703_1.pdf (340.4Kb)
    Date
    2011
    Author
    Christopher Penny
    Dennis Rosero
    David Naylor
    Jacob Friedman
    Metadata
    Show full item record
    Abstract
    Heat transfer to objects immersed in a fluidized bed has been studied extensively across a relatively large range of geometries, though most work has looked at cylinders, a geometry important in power generation fluidized bed applications. As the power generation industry has been the primary stimulant to fluidized bed heat transfer research, very little information is available regarding geometries significant in heat treating applications. In this work, heat transfer to thin flat strips immersed in a fluidized bed is examined. This geometry is important in the steel strap manufacturing industry where many manufacturers use environmentally damaging molten lead baths to heat-treat their product. In order to determine the feasibility of a fluidized bed heat treating system as an alternative to the more hazardous lead-based process, an experimental investigation has been conducted in which Nusselt number data for flat strips with widths in the range of 6.35–25.4 mm are obtained using a laboratory-scale fluidized bed (310 mm diameter). Aluminum oxide sand particles in the range of dp=145–330 μm (50–90 grit) are used as the fluidized media within the fluidized operating range from 0.15Gmf to approximately 10Gmf. The strip orientation angle θo was also varied to establish the position from which maximum heat transfer is obtained. It was found that a decrease in particle diameter, an increase in fluidizing rate, and an increase in sample diameter resulted in an increase in Nusselt number. It was also observed that for the smaller samples tested, a maximum Nusselt number plateau was reached, at approximately G/Gmf=2.5. Finally, it was shown that an increase in θo (from 0 deg to 90 deg) resulted in an increase in Nusselt number. A correlation for the maximum Nusselt number was developed, providing excellent agreement within ±15%.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/146655
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV