Show simple item record

dc.contributor.authorBahman Abbasi
dc.contributor.authorJungho Kim
dc.date.accessioned2017-05-09T00:44:51Z
dc.date.available2017-05-09T00:44:51Z
dc.date.copyrightOctober, 2011
dc.date.issued2011
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27924#101504_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/146579
dc.description.abstractSpray cooling heat transfer measurements of PF-5060 on smooth flat surfaces were obtained using a microheater array operated at constant temperatures using two nozzles (hollow cone and full cone), three nozzle-to-heater standoff distances (3, 5, and 7 mm), four nozzle operating pressures (207 kPa, 345 kPa, 483 kPa, and 689 kPa), and three subcooling levels (11 °C, 21 °C, 31 °C). A separate test setup was used to measure the local normal pressures produced by the sprays. The critical heat flux was found to depend primarily on the local normal pressure and the liquid subcooling. Furthermore, the temperature at which CHF occurred was within a narrow temperature band (about ±5 °C) for smooth flat surfaces over a wide range of spray conditions. The single-phase correlation previously proposed by the authors and the CHF correlation presented in this work were then combined to predict local spray cooling curve within ±25% of the measured values in the spray impingement zone.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePrediction of PF-5060 Spray Cooling Heat Transfer and Critical Heat Flux
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue10
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4004012
dc.journal.fristpage101504
dc.identifier.eissn1528-8943
dc.keywordsPressure
dc.keywordsHeat transfer
dc.keywordsCooling
dc.keywordsSprays
dc.keywordsCritical heat flux
dc.keywordsNozzles AND Temperature
dc.treeJournal of Heat Transfer:;2011:;volume( 133 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record