Show simple item record

dc.contributor.authorA. J. Sequera
dc.contributor.authorR. N. Parthasarathy
dc.contributor.authorS. R. Gollahalli
dc.date.accessioned2017-05-09T00:43:18Z
dc.date.available2017-05-09T00:43:18Z
dc.date.copyrightJune, 2011
dc.date.issued2011
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26576#022203_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/145853
dc.description.abstractMethyl and ethyl esters of vegetable oils have become an important source of renewable energy with convenient applications in compression-ignition (CI) engines. While the use of biofuels results in a reduction of CO, particulate matter, and unburned hydrocarbons in the emissions, the main disadvantage is the increase of nitrogen oxides (NOx ) emissions. The increase in NOx emissions is attributed to differences in chemical composition and physical properties of the biofuel, which in turn affect engine operational parameters such as injection delay and ignition characteristics. The effects of fuel injection timing, which can compensate for these changes, on the performance and emissions in a single cylinder air-cooled diesel engine at partial loads using canola methyl ester and its blends with diesel are presented in this study. The engine is a single cylinder, four stroke, naturally aspirated, CI engine with a displacement volume of 280 cm3 rated at 5 HP at 3600 rpm under a dynamometer load. It was equipped with a pressure sensor in the combustion chamber, a needle lift sensor in the fuel injector, and a crank angle sensor attached to the crankshaft. Additionally, the temperature of the exhaust gases was monitored using a thermocouple inside the exhaust pipe. Pollutant emissions were measured using an automotive exhaust gas analyzer. Advanced, manufacturer-specified standard, and delayed injection settings were applied by placing shims of different thicknesses under the injection pump, thus, altering the time at which the high-pressure fuel reached the combustion chamber. The start of injection was found to be insensitive to the use of biofuels in the engine. The late injection timing of the engine provided advantages in the CO and NO emissions with a small penalty in fuel consumption and thermal efficiency.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Fuel Injection Timing in the Combustion of Biofuels in a Diesel Engine at Partial Loads
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4003808
dc.journal.fristpage22203
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsEngines
dc.keywordsStress
dc.keywordsBiofuel
dc.keywordsCylinders
dc.keywordsDiesel
dc.keywordsDiesel engines
dc.keywordsExhaust systems
dc.keywordsPressure
dc.keywordsEmissions
dc.keywordsneedles
dc.keywordsTemperature AND Fuel consumption
dc.treeJournal of Energy Resources Technology:;2011:;volume( 133 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record