Show simple item record

dc.contributor.authorSuixian Yang
dc.contributor.authorGui Yun Tian
dc.contributor.authorIlham Zainal Abidin
dc.contributor.authorJohn Wilson
dc.date.accessioned2017-05-09T00:43:04Z
dc.date.available2017-05-09T00:43:04Z
dc.date.copyrightJanuary, 2011
dc.date.issued2011
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26541#011008_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/145748
dc.description.abstractThermography has proven to be one of the most effective approaches to detect cracks in conductive specimens over a relatively large area. Pulsed eddy current stimulated thermography is an emerging integrative nondestructive approach for the detection and characterization of surface and subsurface cracks. In this paper, heating behaviors of edge cracks, excited by pulsed eddy currents, are examined using numerical simulations. The simulations are performed using COMSOL multiphysics finite element method simulation software using the AC/DC module. The simulation results show that in the early heating stage, the temperature increases more quickly at the crack tip compared with other points on the sample. The results indicate that to maximize sensitivity, the response should be analyzed in the early stages of the heating period, no more than 100 ms for samples in which we are interested. The eddy current density distribution is changed with a variation in inductor orientation, but the crack tips remain the “hottest” points during the excitation period, which can be used for robust quantitative defect evaluation. Signal feature selection, transient temperature profile of the sample, and influence of the inductor orientation on the detection sensitivity for edge cracks are investigated. The work shows that positioning of the inductor, perpendicular to the crack line, results in the highest sensitivity for defect detection and characterization. The crack orientation can be estimated through the rotation of the linear inductor near the sample edge and the crack tips.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimulation of Edge Cracks Using Pulsed Eddy Current Stimulated Thermography
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4002710
dc.journal.fristpage11008
dc.identifier.eissn1528-9028
dc.keywordsThermography
dc.keywordsEddy currents (Electricity)
dc.keywordsSimulation
dc.keywordsFracture (Materials)
dc.keywordsHeating
dc.keywordsInductors AND Temperature
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2011:;volume( 133 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record