Show simple item record

dc.contributor.authorJohn Goldak
dc.contributor.authorJianguo Zhou
dc.contributor.authorStanislav Tchernov
dc.contributor.authorMahyar Asadi
dc.contributor.authorDan Downey
dc.date.accessioned2017-05-09T00:40:38Z
dc.date.available2017-05-09T00:40:38Z
dc.date.copyrightFebruary, 2010
dc.date.issued2010
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28525#011402_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/144721
dc.description.abstractAn overlay weld repair procedure on a 1066.8×1066.8 mm2 square plate 25.4 mm thick was simulated to compute the 3D transient temperature, microstructure, strain, stress, and displacement of the overlay weld repair procedure. The application for the overlay was the repair of cavitation erosion damage on a large Francis turbine used in a hydroelectric project. The overlay weld consisted of a 4×6 pattern of 100×100 mm2 squares. Each square was covered by 15 weld passes. Each weld pass was 100 mm long. The total length of weld in the six squares was 36 m. The welds in each square were oriented either front-to-back or left-to-right. The welding process was shielded metal arc. The analysis shows that alternating the welding direction in each square produces the least distortion. A delay time of 950 s between the end of one weld pass and the start of the next weld pass was imposed to meet the requirement of a maximum interpass temperature to 50°C.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOptimization of a Weld Overlay on a Plate Structure
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4000511
dc.journal.fristpage11402
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2010:;volume( 132 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record