Show simple item record

dc.contributor.authorAR. Veerappan
dc.contributor.authorS. Soundrapandian
dc.contributor.authorS. Shanmugam
dc.date.accessioned2017-05-09T00:40:33Z
dc.date.available2017-05-09T00:40:33Z
dc.date.copyrightJune, 2010
dc.date.issued2010
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28533#031204_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/144683
dc.description.abstractThinning and ovality are commonly observed irregularities in pipe bends, which induce higher stress than perfectly circular cross sections. In this work, the stresses introduced in pipe bends with different ovalities and thinning for a particular internal pressure are calculated using the finite element method. The constant allowable pressure ratio for different ovalities and thinning is presented at different bend radii. The allowable pressure ratio increases, attains a maximum, and then decreases as the values of ovality and thinning are increased. An empirical relationship to determine the allowable pressure in terms of bend ratio, pipe ratio, percent thinning, and percent ovality is presented. The pipe ratio has a strong effect on the allowable pressure.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Accepting of Pipe Bends With Ovality and Thinning Using Finite Element Method
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4001423
dc.journal.fristpage31204
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsPipe bends
dc.keywordsPipes
dc.keywordsFinite element methods
dc.keywordsStress analysis (Engineering) AND Stress
dc.treeJournal of Pressure Vessel Technology:;2010:;volume( 132 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record