Show simple item record

dc.contributor.authorIzumi Nakamura
dc.contributor.authorAkihito Otani
dc.contributor.authorMasaki Shiratori
dc.date.accessioned2017-05-09T00:40:33Z
dc.date.available2017-05-09T00:40:33Z
dc.date.copyrightJune, 2010
dc.date.issued2010
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28533#031001_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/144677
dc.description.abstractPressurized piping systems used for an extended period may develop degradations such as wall thinning or cracks due to aging. It is important to estimate the effects of degradation on the dynamic behavior and to ascertain the failure modes and remaining strength of the piping systems with degradation through experiments and analyses to ensure the seismic safety of degraded piping systems under destructive seismic events. In order to investigate the influence of degradation on the dynamic behavior and failure modes of piping systems with local wall thinning, shake table tests using 3D piping system models were conducted. About 50% full circumferential wall thinning at elbows was considered in the test. Three types of models were used in the shake table tests. The difference of the models was the applied bending direction to the thinned-wall elbow. The bending direction considered in the tests was either of the in-plane bending, out-of-plane bending, or mixed bending of the in-plane and out-of-plane. These models were excited under the same input acceleration until failure occurred. Through these tests, the vibration characteristic and failure modes of the piping models with wall thinning under seismic load were obtained. The test results showed that the out-of-plane bending is not significant for a sound elbow, but should be considered for a thinned-wall elbow, because the life of the piping models with wall thinning subjected to out-of-plane bending may reduce significantly.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleComparison of Failure Modes of Piping Systems With Wall Thinning Subjected to In-Plane, Out-of-Plane, and Mixed Mode Bending Under Seismic Load: An Experimental Approach
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4001517
dc.journal.fristpage31001
dc.identifier.eissn1528-8978
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsPipes
dc.keywordsFailure AND Piping systems
dc.treeJournal of Pressure Vessel Technology:;2010:;volume( 132 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record