Show simple item record

dc.contributor.authorM. A. Habib
dc.contributor.authorS. Al-Anizi
dc.contributor.authorM. Y. Al-Awwad
dc.contributor.authorI. Al-Zaharnah
dc.contributor.authorM. El-Shafei
dc.contributor.authorM. Hajji
dc.contributor.authorS. A. M. Said
dc.contributor.authorN. Merah
dc.date.accessioned2017-05-09T00:40:27Z
dc.date.available2017-05-09T00:40:27Z
dc.date.copyrightDecember, 2010
dc.date.issued2010
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28536#061301_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/144626
dc.description.abstractIn this paper, different rates of steam flow (swing rates) are used to demonstrate the transient changes in both the drum-boiler steam pressure and the wall temperature levels in addition to stresses in the walls of steam risers. A MATLAB code was written to integrate the nonlinear dynamic governing equations for solving the water volume, the drum pressure, and the steam quality at the exit of the riser tubes. The same code is also used for calculating the steam riser inner and outer wall temperatures based on the inner wall heat transfer coefficient. The temporal riser pipe pressure and the inner and outer pipe wall temperatures have been incorporated into an ANSYS model for calculating the effective combined thermal and pressure-caused stresses numerically. The combined effective stress fluctuation for the highest swing rate (40%) is found to be too low to induce any damage in the riser tube. The controlled pressure level has been compared with an actual pressure reading from an existing drum boiler under operating conditions for the purpose of validating the control parameters employed in the study. An optimization method for reducing the steam pressure overshoot level in the boiler is also proposed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInfluence of Boiler Load Swing Rates on Effective Stresses of Drum Boiler Riser Tubes
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue6
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4001653
dc.journal.fristpage61301
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsFlow (Dynamics)
dc.keywordsTemperature
dc.keywordsStress
dc.keywordsBoilers
dc.keywordsOptimization
dc.keywordsPipeline risers
dc.keywordsSteam
dc.keywordsWater
dc.keywordsEquations AND Exterior walls
dc.treeJournal of Pressure Vessel Technology:;2010:;volume( 132 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record