Show simple item record

dc.contributor.authorP. S. Reddy Gudimetla
dc.contributor.authorR. Adibi-Asl
dc.contributor.authorR. Seshadri
dc.date.accessioned2017-05-09T00:40:25Z
dc.date.available2017-05-09T00:40:25Z
dc.date.copyrightDecember, 2010
dc.date.issued2010
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28536#061201_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/144615
dc.description.abstractIn this paper, a method for determining limit loads in the components or structures by incorporating strain hardening effects is presented. This has been done by including a certain amount of the strain hardening into limit load analysis, which normally idealizes the material to be elastic perfectly plastic. Typical strain hardening curves such as bilinear hardening and Ramberg–Osgood material models are investigated. This paper also focuses on the plastic reference volume correction concept to determine the active volume participating in plastic collapse. The reference volume concept in combination with mα-tangent method is used to estimate lower-bound limit loads of different components. Lower-bound limit loads obtained compare well with the nonlinear finite element analysis results for several typical configurations with/without crack.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleIncorporation of Strain Hardening Effect Into Simplified Limit Analysis
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue6
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4002059
dc.journal.fristpage61201
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsHardening
dc.keywordsWork hardening AND Yield strength
dc.treeJournal of Pressure Vessel Technology:;2010:;volume( 132 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record