Show simple item record

dc.contributor.authorEric A. Browne
dc.contributor.authorGregory J. Michna
dc.contributor.authorMichael K. Jensen
dc.contributor.authorYoav Peles
dc.date.accessioned2017-05-09T00:39:02Z
dc.date.available2017-05-09T00:39:02Z
dc.date.copyrightApril, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27885#041013_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143894
dc.description.abstractThe heat transfer performance of two microjet arrays was investigated using degassed deionized water and air. The inline jet arrays had diameters of 54 μm and 112 μm, a spacing of 250 μm, a standoff of 200 μm (S/d=2.2 and 4.6, H/d=1.8 and 3.7), and jet-to-heater area ratios from 0.036 to 0.16. Average heat transfer coefficients with deionized water were obtained for 150≤Red≤3300 and ranged from 80,000 W/m2 K to 414,000 W/m2 K. A heat flux of 1110 W/cm2 was attained with 23°C inlet water and an average surface temperature of 50°C. The Reynolds number range for the same arrays with air was 300≤Red≤4900 with average heat transfer coefficients of 2500 W/m2 K to 15,000 W/m2 K. The effect of the Mach number on the area-averaged Nusselt number was found to be negligible. The data were compared with available correlations for submerged jet array heat transfer.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Investigation of Single-Phase Microjet Array Heat Transfer
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue4
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4000888
dc.journal.fristpage41013
dc.identifier.eissn1528-8943
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsReynolds number
dc.keywordsWater
dc.keywordsHeat transfer coefficients
dc.keywordsHeat losses
dc.keywordsFlow (Dynamics) AND Fluids
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record