Show simple item record

dc.contributor.authorN. K. C. Selvarasu
dc.contributor.authorNeal E. Blackwell
dc.contributor.authorDanesh K. Tafti
dc.date.accessioned2017-05-09T00:38:56Z
dc.date.available2017-05-09T00:38:56Z
dc.date.copyrightJune, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27889#061702_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143842
dc.description.abstractPrevious investigations on the performance of straight pins, pins with tip clearance, and profiled fins showed that closely packed cylindrical pin fins are very competitive with the modified pins. Therefore, the objective of this paper is to investigate the effect of pin density on performance. Steady/time-dependent calculations are performed to investigate the effect of pin density on friction and heat transfer. Pins packed at distances of SD=1.1, 1.2, 1.3, 1.4, 1.5, 2.0, 2.5, and 3 pin diameters (D) are investigated for 10≤ReD≤600. Two performance measures are used to compare the different pin fin densities. The first measure is to maximize heat transfer capacity for a given pumping power compared with a plane channel. The second measure used is based on entropy generation minimization (EGM), where the objective is to reduce the total irreversibility of the pin fin array to obtain an optimal spacing. Based on the performance measure of maximizing heat capacity, it is shown that for plain channels operating in the laminar range using denser pin packing has distinct advantages with SD=1.1 providing the best augmentation. However, the augmentation in heat capacity becomes relatively independent of the pin density for a channel operating in the turbulent regime. Based on the EGM method, at ReD>200, SD=1.3, 1.4, and 1.5 are the most suitable, with the least entropy generation observed at SD=1.4. At ReD<200, SD=1.1, 1.2, and 1.3 are also suitable for keeping entropy generation low.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Pin Density on Heat-Mass Transfer and Fluid Flow at Low Reynolds Numbers in Minichannels
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue6
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4000949
dc.journal.fristpage61702
dc.identifier.eissn1528-8943
dc.keywordsFriction
dc.keywordsHeat
dc.keywordsHeat transfer
dc.keywordsChannels (Hydraulic engineering)
dc.keywordsDensity
dc.keywordsReynolds number
dc.keywordsEntropy
dc.keywordsFins
dc.keywordsPins (Engineering)
dc.keywordsFluid dynamics
dc.keywordsFlow (Dynamics) AND Turbulence
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record