Show simple item record

dc.contributor.authorHyungdae Kim
dc.contributor.authorHo Seon Ahn
dc.contributor.authorMoo Hwan Kim
dc.date.accessioned2017-05-09T00:38:56Z
dc.date.available2017-05-09T00:38:56Z
dc.date.copyrightJune, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27889#061501_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143839
dc.description.abstractThe pool boiling characteristics of water-based nanofluids with alumina and titania nanoparticles of 0.01 vol % were investigated on a thermally heated disk heater at saturated temperature and atmospheric pressure. The results confirmed the findings of previous studies that nanofluids can significantly enhance the critical heat flux (CHF), resulting in a large increase in the wall superheat. It was found that some nanoparticles deposit on the heater surface during nucleate boiling, and the surface modification due to the deposition results in the same magnitude of CHF enhancement in pure water as for nanofluids. Subsequent to the boiling experiments, the interfacial properties of the heater surfaces were examined using dynamic wetting of an evaporating water droplet. As the surface temperature increased, the evaporating meniscus on the clean surface suddenly receded toward the liquid due to the evaporation recoil force on the liquid-vapor interface, but the nanoparticle-fouled surface exhibited stable wetting of the liquid meniscus even at a remarkably higher wall superheat. The heat flux gain attainable due to the improved wetting of the evaporating meniscus on the fouled surface showed good agreement with the CHF enhancement during nanofluid boiling. It is supposed that the nanoparticle layer increases the stability of the evaporating microlayer underneath a bubble growing on a heated surface and thus the irreversible growth of a hot/dry spot is inhibited even at a high wall superheat, resulting in the CHF enhancement observed when boiling nanofluids.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Mechanism of Pool Boiling Critical Heat Flux Enhancement in Nanofluids
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue6
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4000746
dc.journal.fristpage61501
dc.identifier.eissn1528-8943
dc.keywordsNanoparticles
dc.keywordsBoiling
dc.keywordsEvaporation
dc.keywordsNanofluids
dc.keywordsPool boiling
dc.keywordsWater
dc.keywordsCritical heat flux
dc.keywordsWetting (Surface science) AND Mechanisms
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record