Show simple item record

dc.contributor.authorT. Walker
dc.contributor.authorS.-C. Xue
dc.contributor.authorG. W. Barton
dc.date.accessioned2017-05-09T00:38:54Z
dc.date.available2017-05-09T00:38:54Z
dc.date.copyrightJuly, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27891#072702_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143827
dc.description.abstractA ray-tracing method is presented for numerically determining radiative view factors in complex three-dimensional geometries. This method uses a set of “primitive” shapes to approximate the required geometry together with a Monte Carlo simulation to track the fate of randomized rays leaving each surface. View factors were calculated for an operational fiber drawing furnace using both numerical integration and ray-tracing methods. Calculated view factor profiles were essentially identical above a ray density of 105 per unit area. Run times for the ray-tracing method were considerable longer, although the setup time to describe a new geometry is very short and essentially independent of system complexity.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Determination of Radiative View Factors Using Ray Tracing
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4000974
dc.journal.fristpage72702
dc.identifier.eissn1528-8943
dc.keywordsFurnaces
dc.keywordsPreforms
dc.keywordsRay tracing
dc.keywordsFibers AND Cylinders
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record