Show simple item record

dc.contributor.authorSujoy Kumar Saha
dc.date.accessioned2017-05-09T00:38:52Z
dc.date.available2017-05-09T00:38:52Z
dc.date.copyrightAugust, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27893#081701_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143806
dc.description.abstractThe heat transfer and the pressure drop characteristics of laminar flow of viscous oil (175<Pr<538) through rectangular and square ducts with combined internal axial corrugations on all the surfaces of the ducts and with twisted-tape inserts with and without oblique teeth have been studied experimentally. The axial corrugations in combination with both twisted tapes with and without oblique teeth have been found to perform better than either axial corrugations or twisted-tape inserts acting alone. The heat transfer and the pressure drop measurements have been taken in separate test sections. Heat transfer tests were carried out in electrically heated stainless steel ducts incorporating uniform wall heat flux boundary conditions. Pressure drop tests were carried out in acrylic ducts. The flow friction and thermal characteristics are governed by duct aspect ratio, corrugation angle, corrugation pitch, twist ratio, space ratio, length, tooth horizontal length and tooth angle of the twisted tapes, Reynolds number, and Prandtl number. Correlations developed for friction factor and Nusselt number have predicted the experimental data satisfactorily. The performance of the geometry under investigation has been evaluated. It has been found that based on constant pumping power, up to 45% heat duty increase occurs for the combined axial corrugation and twisted-tape insert case compared with the individual axial corrugation and twisted-tape insert cases in the measured experimental parameters space. On the constant heat duty basis, the pumping power has been reduced up to 30% for the combined enhancement geometry than the individual enhancement geometries.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThermohydraulics of Laminar Flow Through Rectangular and Square Ducts With Axial Corrugation Roughness and Twisted Tapes With Oblique Teeth
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue8
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4001313
dc.journal.fristpage81701
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record