Show simple item record

dc.contributor.authorJason Stafford
dc.contributor.authorYuri S. Muzychka
dc.contributor.authorEd Walsh
dc.contributor.authorVanessa Egan
dc.contributor.authorPat Walsh
dc.date.accessioned2017-05-09T00:38:48Z
dc.date.available2017-05-09T00:38:48Z
dc.date.copyrightSeptember, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27895#091401_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143774
dc.description.abstractThis paper discusses the importance of developing cooling solutions for low profile devices. This is addressed with an experimental and theoretical study on forced convection cooling solution designs that could be implemented into such devices. Conventional finned and corresponding finless designs of equal exterior dimensions are considered for three different heat sink profiles ranging from 1 mm to 4 mm in combination with a commercially available radial blower. The results show that forced convection heat transfer rates can be enhanced by up to 55% using finless designs at low profiles with relatively small footprint areas. Overall, this paper provides optimization and geometry selection criteria, which are relevant to designers of low profile cooling solutions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Novel Approach to Low Profile Heat Sink Design
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue9
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4001626
dc.journal.fristpage91401
dc.identifier.eissn1528-8943
dc.keywordsFlow (Dynamics)
dc.keywordsDesign
dc.keywordsHeat sinks
dc.keywordsHeat transfer AND Forced convection
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record