Show simple item record

dc.contributor.authorArcangelo Messina
dc.contributor.authorGiosué Rollo
dc.date.accessioned2017-05-09T00:37:08Z
dc.date.available2017-05-09T00:37:08Z
dc.date.copyrightMarch, 2010
dc.date.issued2010
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26514#021006_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/142888
dc.description.abstractWithin the frame of industrial automation, the mechanical power related to pneumatic actuator systems involves air flows along with mechanical component, such as valves, connecting tubes, cylinder chambers and possible linkages in order to finally actuate a specific objective. Gas dynamic of the air flowing into connecting ducts plays a fundamental role in the description of the global dynamic phenomena of these systems. Several studies deal with the dynamics of such pneumatic systems but through streamlined analysis where the influence of pressure-waves propagating in ducts is neglected or poorly described. The related models are even more complex when finite volumes are placed at the ends of connecting lines. In this paper, two different mathematical models describing transient pressure-waves propagating through lines closed by finite volumes are presented. The investigation regards pressure and velocity ranges normally operating in industrial pneumatic systems. Besides the value of new system modeling of different complexity, these models are compared from an analytical and numerical point of view; advantages, disadvantages, weakness, abilities, and inabilities are highlighted and, finally, the relevant analysis is corroborated through experimental validations of wave propagating pressure at fixed positions of ducts. This study results both in the presentation of models of practical interest, as well as in an attempt to provide an elucidation on the need to resort to an accurate model rather than a streamlined one with respect to the geometric and/or operative characteristics of industrial pneumatic systems.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Transient of Pressure Waves in Ducts for Systems Operating in Industrial Automation
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4000652
dc.journal.fristpage21006
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2010:;volume( 132 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record