Show simple item record

dc.contributor.authorJong Chull Jo
dc.contributor.authorChang-Yong Choi
dc.contributor.authorYong Kab Lee
dc.contributor.authorWoong Sik Kim
dc.date.accessioned2017-05-09T00:35:14Z
dc.date.available2017-05-09T00:35:14Z
dc.date.copyrightFebruary, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28503#011305_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141876
dc.description.abstractThis paper addresses the numerical simulation of two-phase flow heat transfer in the helically coiled tubes of an integral type pressurized water reactor steam generator under normal operation using a computational fluid dynamics code. The shell-side flow field where a single-phase fluid flows in the downward direction is also calculated in conjunction with the tube-side two-phase flow characteristics. For the calculation of tube-side two-phase flow, the inhomogeneous two-fluid model is used. Both the Rensselaer Polytechnic Institute wall boiling model and the bulk boiling model are implemented for the numerical simulations of boiling-induced two-phase flow in a vertical straight pipe and channel, and the computed results are compared with the available measured data. The conjugate heat transfer analysis method is employed to calculate the conduction in the tube wall with finite thickness and the convections in the internal and external fluids simultaneously so as to match the fluid-wall-fluid interface conditions properly. Both the internal and external turbulent flows are simulated using the standard k-ε model. From the results of the present numerical simulation, it is shown that the bulk boiling model can be applied to the simulation of two-phase flow in the helically coiled steam generator tubes. In addition, the present simulation method is considered to be physically plausible in the light of discussions on the computed results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Simulation of Subcooled Flow Boiling Heat Transfer in Helical Tubes
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3028022
dc.journal.fristpage11305
dc.identifier.eissn1528-8978
dc.keywordsFlow (Dynamics)
dc.keywordsHeat transfer
dc.keywordsFluids
dc.keywordsComputer simulation
dc.keywordsPhase (Wave motion)
dc.keywordsBoiling
dc.keywordsShells
dc.keywordsSubcooling
dc.keywordsNuclear reactor steam generators
dc.keywordsWater
dc.keywordsVapors
dc.keywordsHeat
dc.keywordsVelocity AND Pipes
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record