Show simple item record

dc.contributor.authorC. F. Qian
dc.contributor.authorH. J. Yu
dc.contributor.authorL. Yao
dc.date.accessioned2017-05-09T00:35:13Z
dc.date.available2017-05-09T00:35:13Z
dc.date.copyrightFebruary, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28503#011206_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141869
dc.description.abstractIn order to investigate the possibility of numerical simulation for whole structures of heat exchangers, two finite element analysis models have been established for the fixed tubesheet structure composed of tubesheet, cylindrical shell, and tubes using different types of elements. Stresses and deformations produced by pressure load or thermal load are calculated, and the axial strain at the middle area of the cylindrical shell is experimentally measured. By comparing the numerical results with experimental measurements, it is found that both finite element analysis models can give satisfactory results. Considering the difficulties in modeling heat exchangers, beam and shell elements are recommended.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFinite Element Analysis and Experimental Investigation of Tubesheet Structure
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3027456
dc.journal.fristpage11206
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record