Show simple item record

dc.contributor.authorXiaogui Wang
dc.contributor.authorTianwen Zhao
dc.contributor.authorYanyao Jiang
dc.contributor.authorZengliang Gao
dc.date.accessioned2017-05-09T00:35:10Z
dc.date.available2017-05-09T00:35:10Z
dc.date.copyrightApril, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28506#021402_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141844
dc.description.abstractAn experimental investigation was conducted on the crack growth behavior of a pressure vessel steel, 16MnR, in ambient air. Standard compact tension specimens were subjected to Mode I loading with several R-ratios and loading amplitudes. Three circular notch sizes ranging from very sharp notch to blunt notch were used. In addition to constant amplitude loading, experiments were conducted to study the influences of overload and loading sequence on crack growth. The results show that the R-ratio has an insignificant influence on the crack growth of the material. The size of the notch together with the R-ratio and loading amplitude has a great influence on the early crack growth from the notch. A single tensile overload during a constant amplitude loading experiment retards the crack growth significantly. Right after the application of an overload, the crack growth rate is higher than that of the stable crack growth observed in the constant amplitude loading. The crack growth rate decreases and reaches a minimum value before it gradually increases and reaches the stable crack growth curve. In high-low sequence loading with the maximum load in the second step lower than that of the first loading step, the preceding higher constant amplitude loading results in a significant crack growth retardation in the second loading step. This phenomenon is similar to the effect of a single tensile overload on the constant amplitude loading. An existing model making use of the stress intensity factor is discussed with respect to its capability to describe the observed crack growth behavior with the influence of overload and sequence loading.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Study of the Crack Growth Behavior of 16MnR Pressure Vessel Steel
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3008034
dc.journal.fristpage21402
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record