• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Four-Point Fatigue Testing of Pressurized Composite Pipe

    Thumbnail
    View/Open
    JPVTAS-28510#031402_1.pdf (4.898Mb)
    Date
    2009
    Author
    D. P. Gerrard
    R. J. Scavuzzo
    T. S. Miner
    Olagoke Olabisi
    T. S. Srivatsan
    Metadata
    Show full item record
    Abstract
    This technical paper presents a comparative study of the fatigue strength of high-pressure composite pipes and high-pressure composite pipes containing joints. The test specimens used in this experimental investigation were exposed to cyclic bending stresses and to cyclic bending stresses in combination with constant or cyclic internal pressures generated by water, brine, and crude oil. The extrinsic influence of elevated temperature on fatigue performance was also examined. A new four-point bending fatigue machine was developed at the University of Akron to accomplish the testing. For each test specimen, two types of failure were distinctly observed. After a number of repeated cycles, the fluid under internal pressure began to gradually leak through the fine microscopic cracks in the matrix. The fine microscopic cracks were oriented in the circumferential direction of the pipe. However, despite the occurrence of “weeping failure” of the pipe, internal pressure could be easily maintained. After about 10–100 times the number of cycles required for “weeping,” the fiber reinforcements of the pipe gradually fractured and the internal pressure could no longer be maintained. The loss of pressure is referred to as “pipe failure.” In these tests, the primary parameter controlling failure was orientation of the fiber reinforcements in the body of the pipe. Those fibers aligned along the pipe axis revealed a substantial improvement in cyclic fatigue resistance. The existence of a joint in the test specimen showed secondary importance while contributing to degradation of the fatigue resistance of the specimen. Both types of failure were found to be dependent on temperature, over the range tested (22–66°C, and also dependent on the type of internal liquid used. The specimens tested using crude oil at 66°C as the internal fluid revealed the lowest fatigue resistance.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/141808
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV