Show simple item record

dc.contributor.authorJinyang Zheng
dc.contributor.authorPing Xu
dc.contributor.authorXiufeng Lin
dc.contributor.authorYaxian Li
dc.contributor.authorXiang Li
dc.date.accessioned2017-05-09T00:35:07Z
dc.date.available2017-05-09T00:35:07Z
dc.date.copyrightJune, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28510#031401_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141807
dc.description.abstractPlastic pipe reinforced by cross helically wound steel wires, namely PSP, is a new plastic-matrix steel composite pipe developed in China recently. In order to understand the mechanical properties of PSP under internal pressure, a four-layer analytical model, which considers the torsion caused by the differences between the winding angles of the inner and outer steel wire layers, has been proposed using structural mechanics. The model includes an inner high density polyethylene (HDPE) layer, an inner steel wire layer, an outer steel wire layer, and an outer HDPE layer. To investigate the mechanical properties in inner and outer steel wire layers, the elastic parameters of the composite monolayer plate were deduced from the rectangle outside and circle inside model. During the elastic response of PSP subjected to internal pressure, the stresses and strains in four layers and pressures between the interfaces were obtained. Good agreement between theoretical results and experimental data was observed, which shows that the presented model can be employed to predict stresses, strains, and torsions in PSP. The failure modes and torque values between PSPs manufactured by two different methods were compared, and the influence of the change in the winding angle on the strain in the exterior surface was also discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalyses on the Short-Term Mechanical Properties of Plastic Pipe Reinforced by Cross Helically Wound Steel Wires
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3066826
dc.journal.fristpage31401
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record