Show simple item record

dc.contributor.authorH. Kruggel-Emden
dc.contributor.authorS. Rickelt
dc.contributor.authorS. Wirtz
dc.contributor.authorV. Scherer
dc.date.accessioned2017-05-09T00:35:06Z
dc.date.available2017-05-09T00:35:06Z
dc.date.copyrightJune, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28510#031211_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141798
dc.description.abstractBased on the time-driven discrete element method, granular flow within a hopper is investigated. The main focus is thereby set on hopper vessel design variables such as discharge rates and applied wall pressures. Within the used model contacts are assumed as linear viscoelastic in normal and frictional-elastic in tangential direction. The hopper geometry is chosen according to and (2001, “The Simulation and Experimental Study of Granular Materials Discharged From a Silo With the Placement of Inserts,” Powder Technol., 120(3), pp. 244–255), who performed both experimental and numerical investigations. The considered setup is attractive because it involves only a small number of particles enabling fast modeling. However, the results on the experimental flow rates reported are contradictory and are afflicted with errors. By an analysis of the hopper fill levels at different points of time, the correct average discharge times and flow rates are obtained. Own simulation results are in good agreement with the experimental flow rates and discharge times determined. Based on the thereby defined set of simulation parameters, a sensitivity analysis of parameters such as friction coefficients, stiffnesses, and time steps is performed. As flow properties, besides the overall discharge times, the discharge time averaged axial and radial velocity distributions within the hopper and the normal stresses on the side walls during the first seconds of discharge are considered. The results show a strong connection of the friction coefficients with the discharge times, the velocity distributions, and the stresses on the side walls. Other parameters only reveal a weak often indifferent influence on the studied flow properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Numerical Study on the Sensitivity of the Discrete Element Method for Hopper Discharge
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3122022
dc.journal.fristpage31211
dc.identifier.eissn1528-8978
dc.keywordsVelocity
dc.keywordsFlow (Dynamics)
dc.keywordsParticulate matter
dc.keywordsStress
dc.keywordsElectrical discharge
dc.keywordsDiscrete element methods
dc.keywordsFriction
dc.keywordsSimulation
dc.keywordsGranular materials AND Collisions (Physics)
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record