• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Effect of Precompression on Thickness of Pipe During Bending

    Thumbnail
    View/Open
    JPVTAS-28510#031201_1.pdf (784.7Kb)
    Date
    2009
    Author
    A. V. Kale
    H. T. Thorat
    Metadata
    Show full item record
    Abstract
    Straight pipes with a circular cross section are processed into smooth bends by various pipe bending techniques. After bending, the initial circular cross section is deformed with thickness change. These changes from ideal are normally referred to as “ovality” and “thinning.” Their influence on the subsequent behavior of curved pipes is not yet fully understood. The aim of this paper is to present a factual method to reduce thinning of the wall thickness of pipe during bending. A new mechanism is developed for bending of pipes. This mechanism has a provision of precompression (radial squeeze) of the pipe along the directrix of maximum deformation during bending. This is achieved by clamping the pipe using two parallel plates from top and bottom. In fact, the pipe is wrapped using two rollers—one from inside and one from outside in the horizontal plane—and two plates parallel to the horizontal plane—one from the top and one from the bottom. Experimentation is carried out on this mechanism, and thicknesses are measured at the grid points along the length of the pipe. From the experimental values of thicknesses on the tension and compression sides, dimensionless variations in wall thickness of various groups of pipes are computed for different precompression values. In order to represent the thickness at any point, a mathematical equation is derived. Analytical values of thickness variations on tension and compression sides are computed using this equation. Experimental and analytical results are compared, and its methodical approach is presented in this paper. Results show that precompression reduces thickness variation of the pipe after bending.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/141787
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV