Show simple item record

dc.contributor.authorJ. A. Francis
dc.contributor.authorH. J. Stone
dc.contributor.authorR. B. Rogge
dc.contributor.authorP. J. Withers
dc.contributor.authorL. Karlsson
dc.contributor.authorS. Kundu
dc.contributor.authorH. K. D. H. Bhadeshia
dc.date.accessioned2017-05-09T00:35:03Z
dc.date.available2017-05-09T00:35:03Z
dc.date.copyrightAugust, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28515#041401_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141772
dc.description.abstractResidual stress in the vicinity of a weld can have a large influence on structural integrity. Here the extent to which the martensite-start temperature of the weld filler metal can be adjusted to engineer the residual stress distribution in a bainitic-martensitic steel weld was investigated. Three single-pass groove welds were deposited by manual-metal-arc welding on 12 mm thick steel plates using filler metals designed to have different martensite-start temperatures. Their longitudinal, transverse, and normal residual stress distributions were then characterized across the weld cross section by neutron diffraction. It was found that tensile stresses along the welding direction can be reduced or even replaced with compressive stresses if the transformation temperature is lowered sufficiently. The results are interpreted in the context of designing better welding consumables.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effects of Filler Metal Transformation Temperature on Residual Stresses in a High Strength Steel Weld
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3122036
dc.journal.fristpage41401
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record