Show simple item record

dc.contributor.authorM. M. Hossain
dc.contributor.authorW. D. Reinhardt
dc.contributor.authorR. Seshadri
dc.date.accessioned2017-05-09T00:34:59Z
dc.date.available2017-05-09T00:34:59Z
dc.date.copyrightDecember, 2009
dc.date.issued2009
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28522#061204_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141727
dc.description.abstractThe ASME Boiler and Pressure Vessel Code (code) provides guidelines for the classification of linear elastic stresses into primary, secondary, and peak stresses. Although these guidelines cover a wide range of pressure containing components, the guidelines are sometimes difficult to employ for three-dimensional components with complex geometry. This paper uses the mα-tangent method, an assessment of constraint in the component, based on limit load multiplier estimates as a stress classification tool. The method is applied to several practical pressure vessel components from simple to relatively complex geometric configurations. The results compare well with those obtained by conventional techniques, e.g., inelastic finite element analysis.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimplified Stress Categorization Using a Single Linear Elastic Analysis
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue6
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4000199
dc.journal.fristpage61204
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2009:;volume( 131 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record