Show simple item record

dc.contributor.authorS. Han
dc.contributor.authorR. J. Goldstein
dc.date.accessioned2017-05-09T00:33:57Z
dc.date.available2017-05-09T00:33:57Z
dc.date.copyrightJanuary, 2009
dc.date.issued2009
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27853#012001_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/141149
dc.description.abstractMass transfer measurements are employed as alternative methods for heat transfer measurement because of the difficulty of heat transfer measurements in thin boundary layers, complicated secondary flows, and large thermal gradients. Even though mass transfer experiments are fast and show detailed local measurement data, the conversion of mass transfer results to heat transfer data requires the heat/mass transfer analogy factors in detail. Therefore, the usefulness of mass transfer data depends on finding a simple analogy factor. The heat/mass transfer analogy on a simulated turbine endwall with fillets is evaluated in the present paper. Since the heat/mass transfer analogy factor may not be always the same, the heat/mass transfer analogy should be verified for other different geometries and experimental conditions. To utilize the heat/mass transfer analogy fully, it is necessary to check that the presence of different aerodynamic conditions caused by the fillets affects the heat/mass transfer analogy on a simulated turbine endwall with fillets. To compare heat transfer data and mass transfer data, heat transfer measurements on the endwall with fillets are conducted with a thermal boundary layer measurement technique and mass transfer measurements employing naphthalene sublimation technique on the endwall with the fillets are extracted from literature with equivalent experimental conditions and a similar geometry. As expected by heat transfer and mass transfer equations, the heat/mass transfer analogy factor is applied and shows a good agreement between heat transfer and mass transfer results on the endwall with the fillets from the leading edge to the trailing edge.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Heat/Mass Transfer Analogy for a Simulated Turbine Endwall With Fillets
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue1
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2969756
dc.journal.fristpage12001
dc.identifier.eissn1528-8943
dc.keywordsHeat
dc.keywordsMass transfer
dc.keywordsHeat transfer AND Turbines
dc.treeJournal of Heat Transfer:;2009:;volume( 131 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record