Show simple item record

dc.contributor.authorGregory J. Michna
dc.contributor.authorEric A. Browne
dc.contributor.authorYoav Peles
dc.contributor.authorMichael K. Jensen
dc.date.accessioned2017-05-09T00:33:33Z
dc.date.available2017-05-09T00:33:33Z
dc.date.copyrightNovember, 2009
dc.date.issued2009
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27874#111402_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140937
dc.description.abstractAn investigation of the pressure drop and impingement zone heat transfer coefficient trends of a single-phase microscale impinging jet was undertaken. Microelectromechanical system (MEMS) processes were used to fabricate a device with a 67-μm orifice. The water jet impinged on an 80-μm square heater on a normal surface 200 μm from the orifice. Because of the extremely small heater area, the conjugate convection-conduction heat transfer process provided an unexpected path for heat losses. A numerical simulation was used to estimate the heat losses, which were quite large. Pressure loss coefficients were much higher in the range Red,o<500 than those predicted by available models for short orifice tubes; this behavior was likely due to the presence of the wall onto which the jet impinged. At higher Reynolds numbers, much better agreement was observed. Area-averaged heat transfer coefficients up to 80,000 W/m2 K were attained in the range 70<Red<1900. This corresponds to a 400 W/cm2 heat flux at a 50°C temperature difference. However, this impingement zone heat transfer coefficient is nearly an order-of-magnitude less than that predicted by correlations developed from macroscale jet data, and the dependence on the Reynolds number is much weaker than expected. Further investigation of microjet heat transfer is needed to explain the deviation from expected behavior.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSingle-Phase Microscale Jet Stagnation Point Heat Transfer
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.3154750
dc.journal.fristpage111402
dc.identifier.eissn1528-8943
dc.keywordsPressure
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsMicroscale devices
dc.keywordsHeat losses
dc.keywordsPressure drop
dc.keywordsWater
dc.keywordsHeat transfer coefficients
dc.keywordsReynolds number
dc.keywordsFlow (Dynamics)
dc.keywordsJets
dc.keywordsFluids AND Convection
dc.treeJournal of Heat Transfer:;2009:;volume( 131 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record