Show simple item record

dc.contributor.authorD. Keith Hollingsworth
dc.contributor.authorLarry C. Witte
dc.contributor.authorMarcelino Figueroa
dc.date.accessioned2017-05-09T00:33:31Z
dc.date.available2017-05-09T00:33:31Z
dc.date.copyrightDecember, 2009
dc.date.issued2009
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27876#121005_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140916
dc.description.abstractThe time-dependent temperature distribution on an inclined, thin-foil uniform-heat-generation heater was used to infer the heat transfer enhancement caused by the passage of an FC-87 bubble sliding beneath the lower surface of the heater. A two-camera system was used: One camera recorded color images of a liquid crystal layer applied to the upper (dry) side of the heater while a second camera simultaneously recorded the position, size, and shape of the bubble from below. The temperature response of the heater could then be correlated directly to the bubble characteristics at any given time during its passage. The data along the line bisecting the bubble wake from the nine bubbles comprising 54 bubble images were analyzed. The heat transfer in the wake behind the sliding cap-shaped bubbles is very effective compared with the natural convection that occurs before the passage of the bubble. The maximum values of heat transfer coefficient in the range of 2500 W/m2 K were produced in very sharply peaked curves. The point of maximum cooling measured as a fraction of the local driving temperature difference before the bubble passage was identified and correlated with some success to the streamwise length of the bubble. The location of the maximum heat transfer coefficient was reasonably correlated with bubble width. The level of the maximum heat transfer coefficient when cast as a Nusselt number based on bubble width grew to a saturation value as the bubble moved across the plate. A constant value of Nusselt number requires that the heat transfer coefficient falls as the bubble grows past some critical bubble size. This behavior was observed for the larger cap-shaped bubbles.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEnhancement of Heat Transfer Behind Sliding Bubbles
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue12
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.3216039
dc.journal.fristpage121005
dc.identifier.eissn1528-8943
dc.keywordsHeat transfer
dc.keywordsBubbles
dc.keywordsTemperature AND Wakes
dc.treeJournal of Heat Transfer:;2009:;volume( 131 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record