Show simple item record

dc.contributor.authorTimothy R. Walter
dc.contributor.authorAndrew W. Richards
dc.contributor.authorGhatu Subhash
dc.date.accessioned2017-05-09T00:32:59Z
dc.date.available2017-05-09T00:32:59Z
dc.date.copyrightJanuary, 2009
dc.date.issued2009
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27113#011009_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140629
dc.description.abstractTensile and compressive stress-strain responses were obtained for various densities of polymer foams. These experimental data were used to determine relevant engineering parameters (such as elastic moduli in tension and compression, ultimate tensile strength, etc.) as a function of foam density. A phenomenological model applicable for both compressive and tensile responses of polymeric foams is validated by comparing the model to the experimentally obtained compression and tensile responses. The model parameters were analyzed to determine the effect of each parameter on the mechanical response of the foam. The engineering parameters were later compared to the appropriate model parameters and a good correlation was obtained. It was shown that the model indeed captures the entire compressive and tensile response of polymeric foams effectively.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Unified Phenomenological Model for Tensile and Compressive Response of Polymeric Foams
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3026556
dc.journal.fristpage11009
dc.identifier.eissn1528-8889
dc.keywordsDensity
dc.keywordsPlastic foam
dc.keywordsStress
dc.keywordsCollapse
dc.keywordsCompression
dc.keywordsElastic moduli AND Tension
dc.treeJournal of Engineering Materials and Technology:;2009:;volume( 131 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record