Show simple item record

dc.contributor.authorMatteo Galli
dc.contributor.authorJolanta Janczak-Rusch
dc.contributor.authorGerd Maier
dc.contributor.authorUdo Welzel
dc.contributor.authorJohn Botsis
dc.date.accessioned2017-05-09T00:32:56Z
dc.date.available2017-05-09T00:32:56Z
dc.date.copyrightApril, 2009
dc.date.issued2009
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27117#021004_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140605
dc.description.abstractResidual stress relief in ceramic-metal joints produced by active brazing depends primarily on the plastic response of the filler metal. A procedure for the production and mechanical characterization of bulk active filler alloy specimens is developed. In parallel ceramic-metal joints are produced and tested. Residual stresses are measured by X-ray diffraction while the joint strength is assessed by four-point bend tests. The obtained elastoplastic properties of the filler are introduced into finite element models to predict the residual stresses in the joints and their behavior in bending. The results of the simulations show good agreement both with the residual stress measurements and with the results of four-point bend tests.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCharacterization of the Residual Stresses and Strength of Ceramic-Metal Braze Joints
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3078305
dc.journal.fristpage21004
dc.identifier.eissn1528-8889
dc.keywordsCeramics
dc.keywordsMeasurement
dc.keywordsFillers (Materials)
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsBrazing
dc.keywordsMetals AND Alloys
dc.treeJournal of Engineering Materials and Technology:;2009:;volume( 131 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record