Show simple item record

dc.contributor.authorEun-chae Jeon
dc.contributor.authorJoo-Seung Park
dc.contributor.authorDoo-Sun Choi
dc.contributor.authorKug-Hwan Kim
dc.contributor.authorDongil Kwon
dc.date.accessioned2017-05-09T00:32:54Z
dc.date.available2017-05-09T00:32:54Z
dc.date.copyrightJuly, 2009
dc.date.issued2009
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27120#031006_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140588
dc.description.abstractThe instrumented indentation test, which measures indentation tensile properties, has attracted interest recently because this test can replace uniaxial tensile test. An international standard for instrumented indentation test has been recently legislated. However, the uncertainty of the indentation tensile properties has never been estimated. The indentation tensile properties cannot be obtained directly from experimental raw data as can the Brinell hardness, which makes estimation of the uncertainty difficult. The simplifying uncertainty estimation model for the indentation tensile properties proposed here overcomes this problem. Though the influence quantities are generally defined by experimental variances when estimating uncertainty, here they are obtained by calculation from indentation load-depth curves. This model was verified by round-robin test with several institutions. The average uncertainties were estimated as 18.9% and 9.8% for the indentation yield strength and indentation tensile strength, respectively. The values were independent of the materials’ mechanical properties but varied with environmental conditions such as experimental instruments and operators. The uncertainties for the indentation yield and tensile strengths were greater than those for the uniaxial tensile test. These larger uncertainties were caused by measuring local properties in the instrumented indentation test. The two tests had the same tendency to have smaller uncertainties for tensile strength than yield strength. These results suggest that the simplified model can be used to estimate the uncertainty in indentation tensile properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Method for Estimating Uncertainty of Indentation Tensile Properties in Instrumented Indentation Test
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3120391
dc.journal.fristpage31006
dc.identifier.eissn1528-8889
dc.keywordsUncertainty
dc.keywordsYield strength AND Tensile strength
dc.treeJournal of Engineering Materials and Technology:;2009:;volume( 131 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record