Show simple item record

dc.contributor.authorPrabir Basu
dc.contributor.authorJames Butler
dc.contributor.authorAnimesh Dutta
dc.contributor.authorMunish Chandel
dc.date.accessioned2017-05-09T00:32:23Z
dc.date.available2017-05-09T00:32:23Z
dc.date.copyrightDecember, 2009
dc.date.issued2009
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26566#041401_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140336
dc.description.abstractLoop-seal is a critical component of a circulating fluidized bed (CFB) boiler, and yet very little information on its working or design is available in published literature. Among the limited available information, none is on twin-exit loop-seal though it is one of the most commonly used loop-seal in large commercial CFB boilers. To circulate larger amounts of solids, a twin-exit loop-seal provides larger solids flow sections. It receives solids from one standpipe but delivers it through two recycle chambers and two delivery pipes. The present research was conducted in a twin-exit loop-seal of a 3.2 MWth CFB boiler operating in a thermal power plant for cofiring purpose. Data obtained in this industrial unit were supplemented with those collected in a single-exit bench-scale loop-seal in the authors’ laboratory from the single-exit loop-seal in a 65 t/h CFB boiler and a scale model of a 30 MW CFB boiler. The effect of recycle chamber’s aeration on the solids circulation rate was studied for several particle sizes. Results suggest that the total solids circulation rate does not increase proportionately with the increase in loop-seal discharge area provided by the twin-exit loop-seals. The linear horizontal velocities of solids and the minimum aeration in the recycle chambers are comparable to those measured in a single-exit loop-seal. The implication of these new findings on the design procedure of loop-seals is discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Investigation Into the Operation of the Twin-Exit Loop-Seal of a Circulating Fluidized Bed Boiler in a Thermal Power Plant and Its Design Implication
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4000174
dc.journal.fristpage41401
dc.identifier.eissn1528-8994
dc.keywordsFlow (Dynamics)
dc.keywordsSolids
dc.keywordsFluidization
dc.keywordsBoilers
dc.keywordsDesign
dc.keywordsParticulate matter
dc.keywordsThermal power stations AND Air flow
dc.treeJournal of Energy Resources Technology:;2009:;volume( 131 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record