Show simple item record

dc.contributor.authorAngelo Bonfitto
dc.contributor.authorAndrea Tonoli
dc.contributor.authorXavier De Lépine
dc.contributor.authorMario Silvagni
dc.date.accessioned2017-05-09T00:32:07Z
dc.date.available2017-05-09T00:32:07Z
dc.date.copyrightNovember, 2009
dc.date.issued2009
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26505#061006_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/140171
dc.description.abstractThe aim of this paper is to investigate the potential of a self-sensing strategy in the case of an electromagnetic damper for the vibration control of flexible structures and rotors. The study has been performed in the case of a single degree of freedom mechanical oscillator actuated by a couple of electromagnets. The self-sensing system is based on a Luenberger observer. Two sets of parameters have been used: nominal ones (based on simplifications on the actuator model) and identified ones. In the latter case, the parameters of the electromechanical model used in the observer are identified starting from the open-loop system response. The observed states are used to close a state-feedback loop with the objective of increasing the damping of the system. The results show that the damping performance are good in both cases, although much better in the second one. Furthermore, the good correlation between the closed-loop model response and the experimental results validates the modeling, the identification procedure, the control design, and its implementation. The paper concludes on a sensitivity analysis, in which the influence of the model parameters on the closed-loop response is shown.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSelf-Sensing Active Magnetic Dampers for Vibration Control
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue6
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4000069
dc.journal.fristpage61006
dc.identifier.eissn1528-9028
dc.keywordsElectric potential
dc.keywordsControl equipment
dc.keywordsVibration control
dc.keywordsActuators
dc.keywordsDampers
dc.keywordsDamping
dc.keywordsDesign
dc.keywordsModeling
dc.keywordsElectromagnets
dc.keywordsSensitivity analysis
dc.keywordsState feedback
dc.keywordsStiffness
dc.keywordsOpen loop systems
dc.keywordsForce
dc.keywordsClosed loop systems
dc.keywordsDynamics (Mechanics)
dc.keywordsRotors AND Degrees of freedom
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2009:;volume( 131 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record