Show simple item record

dc.contributor.authorQuamrul H. Mazumder
dc.contributor.authorSiamack A. Shirazi
dc.contributor.authorBrenton McLaury
dc.date.accessioned2017-05-09T00:30:21Z
dc.date.available2017-05-09T00:30:21Z
dc.date.copyrightFebruary, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28489#011303_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139241
dc.description.abstractErosive wear damage of elbows due to solid particle impact has been recognized as a significant problem in several fluid handling industries. Solid particle erosion is a complex phenomenon due to different parameters causing material removal from the metal surface. The particle density, size, shape, velocity, concentration, impact angle, and impacting surface material properties are some of the major parameters. Among the various factors, the particle impact velocity has the greatest influence in erosion. The particle impact velocity and impact angles depend on the fluid velocity and fluid properties. The particle to particle, particle to fluid, and particle to wall interactions increase the complexity of the erosive wear behavior. In multiphase flow, the presence of different fluids and their corresponding spatial distribution of the phases, adds another dimension to the problem. Most of the previous investigations were focused on determination of erosion in terms of mass loss of the eroding surfaces without identifying the specific location of the maximum erosive wear. During this investigation, magnitude of erosion at different location of an elbow specimen was measured to determine the location of maximum erosion. Experimental investigation of erosion in single-phase and multiphase flows was conducted at different fluid velocities. Both mass loss and thickness loss measurements were taken to characterize erosion behavior and erosion patterns in an elbow. Experimental results showed different erosion behavior and location of maximum erosion damage in single-phase and multiphase flows. The locations of maximum wear due to erosion were also different for horizontal flow compared to vertical flow.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Investigation of the Location of Maximum Erosive Wear Damage in Elbows
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2826426
dc.journal.fristpage11303
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record