Show simple item record

dc.contributor.authorY. Kisioglu
dc.contributor.authorJ. R. Brevick
dc.contributor.authorG. L. Kinzel
dc.date.accessioned2017-05-09T00:30:20Z
dc.date.available2017-05-09T00:30:20Z
dc.date.copyrightFebruary, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28489#015001_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139225
dc.description.abstractThis study addresses the design of DOT-4BA refillable cylinders using both experimental and numerical approaches. Using traditional design methods, these cylinders often experience buckling on the bottom end closure during pressure testing. A finite element analysis (FEA) design tool was developed using axisymmetric material nonlinear conditions to predict the buckling of the cylinder bottom end closures. The FEA model was also used to evaluate the influence of variations in end-closure geometry, material thickness, and strength on buckling. In addition, an optimization algorithm was employed to minimize end-closure material (weight) without buckling when they are subjected to their specified test pressure. Experimental studies were conducted via hydrostatic pressure tests with water at the R&D laboratories of a cylinder manufacturer. The axisymmetric nonlinear FEA models were developed successfully, and the obtained results are compared with experimental test results from cylinder manufacturer case studies.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMinimum Material Design for Propane Cylinder End Closures
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2826458
dc.journal.fristpage15001
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record