Show simple item record

dc.contributor.authorJ. Błachut
dc.contributor.authorI. B. Iflefel
dc.date.accessioned2017-05-09T00:30:17Z
dc.date.available2017-05-09T00:30:17Z
dc.date.copyrightMay, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28493#021203_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139206
dc.description.abstractSix laboratory scale, mild steel pipes with the outside diameter-to-wall-thickness ratio, Do∕t≅40, were dented to about 15–20% of outside diameter Do, by a hemispherical indenter with its diameter to pipe’s outside diameter ratio, 2a∕Do≅0.41. Three pipes had surface gouges running axially in them, and the remaining three were gouge free. Five of them were then collapsed by a bending moment followed by pressure burst tests. Experimental test data has been used to benchmark the finite element results, details of which are given in this paper. Good agreement between experimental and numerical results was obtained in the modeling of denting, but not so well in the modeling of bending—indicating the need for further work in order to address the discrepancies.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental and Numerical Investigation of Plain and Gouged Dents in Steel Pipes Subjected to Pressure and Moment Loading
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2891913
dc.journal.fristpage21203
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record