Show simple item record

dc.contributor.authorTakashi Ogata
dc.date.accessioned2017-05-09T00:30:16Z
dc.date.available2017-05-09T00:30:16Z
dc.date.copyrightAugust, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28496#031404_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139195
dc.description.abstractHigh temperature components in thermal power plants are subjected to creep-fatigue loading where creep cavities initiate and grow on grain boundaries. Development of a quantitative evaluation method of cavity growth is important for reliable maintenance of these components. In this study, a creep-fatigue test was carried out at 600°C on 2.25Cr–1Mo steel in a scanning electron microscope, and continuous observation of cavity growth behavior during the test was made. Based on the cavity growth observation, existing cavity growth models were modified and the simulated results using the modified model were compared to the observed cavity growth behavior. From the observation, spherical shape cavities initiate and grow up to their length of 2μm on the grain boundaries at the initial stage of damage, and then these cavities change their shape to cracklike and grow until their length reaches around 10μm. Finally, cracklike cavities coalesce with each other to form one microcrack along a grain boundary. It can be concluded that cavity growth rates are controlled by diffusion and power law creep under constrained conditions, based on the theoretical consideration of cavity growth mechanism. Through these discussions, a new cavity growth model was proposed by modifying conventional models. Both spherical and cracklike cavity growth rate equations were derived from the modified cavity growth model. It was indicated that the measured cavity growth rate was well predicted by the growth rate equations, derived from the modified model, and a cavity growth simulation result corresponds to the change in the maximum cavity size with number of cycles under the creep-fatigue loading.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCavity Growth Simulation in 2.25Cr–1Mo Steel Under Creep-Fatigue Loading
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2937735
dc.journal.fristpage31404
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record