Show simple item record

dc.contributor.authorAndrew H. Sherry
dc.contributor.authorMark A. Wilkes
dc.contributor.authorPeter J. Budden
dc.contributor.authorJohn K. Sharples
dc.date.accessioned2017-05-09T00:30:11Z
dc.date.available2017-05-09T00:30:11Z
dc.date.copyrightNovember, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28499#041212_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139163
dc.description.abstractThis paper presents the results of a numerical study undertaken to assess the influence of residual stresses on the ductile tearing behavior of a high strength low toughness aluminum alloy. The Gurson–Tvergaard model was calibrated against conventional fracture toughness data using parameters relating to void nucleation, growth, and coalescence. The calibrated model was used to predict the load versus ductile tearing behavior of a series of full-scale and quarter-scale wide-plate tests. These center-cracked tension tests included specimens that contained a self-balancing residual stress field that was tensile in the region of the through-wall crack. Analyses of the full-scale wide-plate tests indicated that the model provides a good prediction of the load versus the ductile tearing behavior up to approximately 3mm of stable tearing. The influence of residual stress on the load versus the crack growth behavior was accurately simulated. Predictions of the load versus the crack growth behavior of full-scale wide-plate tests for crack extensions greater than 3mm and of the quarter-scale tests were low in terms of predicted load at a given amount of tearing. This was considered to result from (i) the “valid” calibration range in terms of specimen thickness and crack extension, (ii) the development of shear lips, and (iii) the differences in the micromechanism of ductile void formation under plane strain and under plane stress conditions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Assessment of Residual Stress Effects on Ductile Tearing Using Continuum Damage Mechanics
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2967876
dc.journal.fristpage41212
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsStress
dc.keywordsPlane strain
dc.keywordsDuctile fracture
dc.keywordsFracture (Process)
dc.keywordsCalibration
dc.keywordsResidual stresses
dc.keywordsThickness
dc.keywordsFracture toughness
dc.keywordsToughness AND Tension
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record