Show simple item record

dc.contributor.authorXinjian Duan
dc.contributor.authorSandra Pagan
dc.contributor.authorBrian Mills
dc.contributor.authorMichael J. Kozluk
dc.date.accessioned2017-05-09T00:30:11Z
dc.date.available2017-05-09T00:30:11Z
dc.date.copyrightNovember, 2008
dc.date.issued2008
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28499#041207_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/139158
dc.description.abstractAging steam generator tubes have been experiencing a variety of degradations such as pitting, fretting wear, erosion-corrosion, thinning, cracking, and denting. To assist with steam generator life cycle management, some defect-specific flaw models have been developed from burst pressure testing results. In this work, an alternative approach; heterogeneous finite element model (HFEM), is explored. The HFEM is first validated by comparing the predicted failure modes and failure pressure with experimental measurements of several tubes. Several issues related to the finite element analyses such as temporal convergence, mesh size effect, and the determination of critical failure parameters are detailed. The HFEM is then applied to predict the failure pressure for use in a fitness-for-service condition monitoring assessment of one removed steam generator tube. HFEM not only calculates the correct failure pressure for a variety of defects, but also predicts the correct change of failure mode. The Taguchi experimental design method is also applied to prioritize the flaw dimensions that affect the integrity of degraded steam generator tubes such as the defect length, depth, and width. It has been shown that the defect depth is the dominant parameter controlling the failure pressure. The failure pressure varies almost linearly with defect depth when the defect length is greater than two times the tube diameter. An axial slot specific flaw model is finally developed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStructural Integrity Assessment of Steam Generator Tube by the Use of Heterogeneous Finite Element Method
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2967727
dc.journal.fristpage41207
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2008:;volume( 130 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record