• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Modeling the Effects of Initial Tube-Tubesheet Clearance, Wall Reduction and Material Strain Hardening on Rolled Joint Strength

    Thumbnail
    View/Open
    JPVTAS-28499#041204_1.pdf (609.2Kb)
    Date
    2008
    Author
    A. Al-Aboodi
    N. Merah
    S. S. Al-Anizi
    A. R. Shuaib
    Y. Al-Nassar
    Metadata
    Show full item record
    Abstract
    The tube-to-tubesheet joint strength is measured in terms of residual contact pressure between the tube’s outer surface and tubesheet hole surfaces. The joint integrity is affected by several design parameters, including the type of tube and tubesheet materials, the level of expansion, and the initial radial clearance between the tube and tubesheet. In the present work, an axisymmetric finite element model based on the sleeve diameter and rigid roller concepts is developed. The model has been used to evaluate the combined effects of clearance, wall reduction level, and strain hardening of tube and tubesheet materials on the interfacial pressure between tube and tubesheet. The finite element results show that the initial clearance effect is dependent on the strain hardening capability of the tube material. For low strain hardening tube materials, the interfacial pressure remains almost constant well above the Tubular Exchanger Manufacturing Association maximum radial over tolerance of 0.0254mm(0.001in.). These results are validated by the experimental data developed during the research program. As expected, a drastic reduction in joint strength is observed at high values of radial clearances. The cutoff clearance (clearance at which the interfacial pressure starts to drop) is found to vary linearly with tube material hardening level. The residual pressure is found to increase slightly for moderate strain hardening tube materials but shows lower cutoff clearances. Wall reductions ranging from 1% to 12% were utilized in calculating the contact pressure as a function of radial clearance. The results show that for low strain hardening materials the optimum value of residual contact stress is obtained for the industry recommended value of 5%. Finally, because of the absence of plastic deformation in the ligament, the level of tubesheet material strain hardening does not have any noticeable effect on the joint strength.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/139154
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV