Show simple item record

dc.contributor.authorS. K. Saha
dc.contributor.authorK. Srinivasan
dc.contributor.authorP. Dutta
dc.date.accessioned2017-05-09T00:29:12Z
dc.date.available2017-05-09T00:29:12Z
dc.date.copyrightMarch, 2008
dc.date.issued2008
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27833#034505_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138601
dc.description.abstractThis paper deals with phase change material (PCM), used in conjunction with thermal conductivity enhancer (TCE), as a means of thermal management of electronic systems. Eicosane is used as PCM, while aluminium pin or plate fins are used as TCE. The test section considered in all cases is a 42×42mm2 base with a TCE height of 25mm. An electrical heater at the heat sink base is used to simulate the heat generation in electronic chips. Various volumetric fractions of TCE in the conglomerate of PCM and TCE are considered. The case with 8% TCE volume fraction was found to have the best thermal performance. With this volume fraction of TCE, the effects of fin dimension and fin shape are also investigated. It is found that a large number of small cross-sectional area fins is preferable. A numerical model is also developed to enable an interpretation of experimental results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStudies on Optimum Distribution of Fins in Heat Sinks Filled With Phase Change Materials
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue3
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2804948
dc.journal.fristpage34505
dc.identifier.eissn1528-8943
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsPhase change materials
dc.keywordsFins
dc.keywordsHeat sinks
dc.keywordsDimensions
dc.keywordsAluminum
dc.keywordsThermal management AND Thermal conductivity
dc.treeJournal of Heat Transfer:;2008:;volume( 130 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record