Show simple item record

dc.contributor.authorXin Feng
dc.contributor.authorJames E. Bryan
dc.date.accessioned2017-05-09T00:29:02Z
dc.date.available2017-05-09T00:29:02Z
dc.date.copyrightJuly, 2008
dc.date.issued2008
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27839#072202_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138526
dc.description.abstractThe effect of electric fields applied to two-phase impingement heat transfer is explored for the first time. The electric field applied between a capillary tube and heated surface enhances the heat transfer by controlling the free boundary flow modes from discreet drops to jets, to sprays. Through an experimental study, the impingement heat transfer was evaluated over a range of operating conditions and geometrical parameters with subcooled ethanol used as the working fluid. The ability to change the mode of impinging mass did change the surface heat transfer. The characteristics of the impinging mass on heat transfer were dependent on flow rate, applied voltage, capillary tube to heated surface spacing, capillary tube geometry, heat flux, heater surface geometry, and capillary tube array configuration. Enhancement occurred primarily at low heat fluxes (below 30W∕cm2) under ramified spray conditions where the droplet momentum promoted thin films on the heated surface resulting in 1.7 times enhancement under certain conditions. Higher heat fluxes resulted in greater vapor momentum from the surface, minimizing the effect of different impingement modes. The use of capillary tube array allowed for electrohydrodynamics atomization enhancement and higher liquid flow rates, but electrostatic repulsive forces diverted the spray from the heater surface. This reduced the mass flux to the surface, leading to premature dryout under certain conditions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleApplication of Electrohydrodynamic Atomization to Two-Phase Impingement Heat Transfer
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2885178
dc.journal.fristpage72202
dc.identifier.eissn1528-8943
dc.keywordsFlow (Dynamics)
dc.keywordsHeat transfer
dc.keywordsElectric fields
dc.keywordsElectric potential
dc.keywordsMomentum
dc.keywordsSprays
dc.keywordsForce AND Heat flux
dc.treeJournal of Heat Transfer:;2008:;volume( 130 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record